ANSYS Maxwell Course ~ Modeling and Multiphysics Simulation
20-Session Syllabus
Modeling and Multiphysics Simulation of High-Speed Axial Flux Motors for Aerospace Applications Using ANSYS Maxwell
Session 1
Introduction to Axial Flux Motors and Aerospace Applications
-
Definition of axial flux motors
-
Comparison of radial vs. axial flux
-
Performance requirements in the aerospace industry
Session 2
Electromagnetic Fundamentals for Motor Simulation
-
Faraday's Law, Lorentz Law, and Maxwell's Equations
-
Magnetic field behavior in electric motors
Session 3
Introduction to ANSYS Maxwell
-
Maxwell 2D vs. Maxwell 3D interface
-
Environment setup and key features
Session 4
Preparing Geometry for a Simple Axial Flux Motor
-
Creating stator, rotor, and permanent magnet models
-
Setting units and basic design parameters
Session 5
Material Selection and Assignment
-
Selecting materials (soft magnetic, permanent magnets, insulation)
-
Assigning material properties in ANSYS
Session 6
Meshing Strategies for Axial Flux Models
-
Global and local meshing
-
Tips for achieving accurate results without excessive computational time
Session 7
Boundary Conditions and Excitation Setup
-
Defining boundaries, coil excitation, and symmetry
-
Setting up initial conditions for simulation
Session 8
Steady-State Magnetic Simulation
-
Running DC or low-speed simulations for initial validation
-
Interpreting field distribution and flux path results
Session 9
Transient Magnetic Simulation for High-Speed Analysis



