Proteus Course ~ Mastering Proteus From Basics to Simulation Creation
Below is a 20-Session Syllabus @1.5 hours each for the Proteus course suitable for students to support their thesis, master's thesis, and doctoral dissertation in the fields of electronics, mechatronics, and electrical engineering.
The focus of this syllabus is mastering Proteus from basics to creating complete embedded system simulations.
Final Target: Participants will be able to create circuits, program microcontrollers, integrate sensors/actuators, and run complete system simulations in Proteus.
Module 1 – Introduction & Proteus Basics
Session 1. Proteus Introduction & Interface
-
Objective: Understand Proteus functionality, main modules (ISIS & ARES).
-
Materials: Proteus Design Suite installation
-
Main menu, toolbar, and component panel
-
Difference between ISIS (simulation) and ARES (PCB Layout)
-
Practice: Creating a simple LED circuit with DC source.
Session 2. Component & Library Management
-
Materials: Finding and adding components
-
Importing external libraries (IC, sensors, microcontrollers)
-
Managing component packages (footprints)
-
Practice: Creating a blinking LED circuit using ON/OFF button.
Session 3. Basic Circuit Simulation
-
Materials: AC/DC voltage sources
-
Resistor, capacitor, diode, transistor
-
Measurements using virtual oscilloscope, voltmeter, ammeter
-
Practice: Simulating half-wave and full-wave rectifier circuits.
Session 4. Analog Circuit Analysis
-
Materials: Op-amp (inverting & non-inverting)
-
RC filter (low-pass, high-pass)
-
Practice: Simulating a simple audio amplifier with LM741.
Module 2 – Digital & Microcontroller
Session 5. Basic Digital Circuits
-
Materials: Logic gates (AND, OR, NOT, XOR)
-
Flip-flop and simple counter
-
Practice: Creating a running light circuit (LED Chaser) with IC 4017.



