Memuat
Memuat
Below rated speed the turbine tracks maximum power; above it the pitch angle holds the rotor speed.
0 views
A 2 MW wind turbine with a 40 m rotor radius. The power coefficient Cp is read from a 2-D table over tip speed ratio and pitch angle; the generator uses torque K times omega squared (MPPT) clipped at rated torque, and a PI controller adjusts the pitch when the rotor speed exceeds its rated value, with a rate limit and a first-order actuator.

Wind of 8 m/s plus sines and a Step gust smoothed by a 3 s rotor filter.
The tip speed ratio comes from rotor speed and wind, Cp from a 2-D Lookup, then the aerodynamic torque from the wind power formula.
Inertia times angular acceleration equals aerodynamic torque minus generator torque and friction.
Torque = K times omega squared, limited to rated torque; power is torque times speed.
A PI on the speed error with the integrator clamped to 0 to 30 degrees and a 4 degree-per-second maximum rate.
System
A 2 MW turbine with a 40 m rotor radius and a Cp table from the Heier formula (λ 0.5 to 16, pitch 0 to 30 degrees).
Scenario
A 600 s simulation with a 0.01 s step and 8 m/s mean wind with turbulence and a gust.
Note: A one-mass model without tower, drivetrain or electrical generator dynamics; Cp uses an empirical formula, not data from a specific turbine.
Simulink model turbin_angin_pitch.slx (standard block diagram); Builder script buat_model.m and runner jalankan.m; Result plots grafik_turbin (PNG) and metrik.json; Step-by-step PDF guide (sent with the package; also part of the video class); Video tutorial in the MATLAB Simulink 2026 Trends class (this project's episode; episode 1 is free); Requires MATLAB and Simulink (built in R2025b); the slh.m builder helper is included.
Yes. The .slx model opens in MATLAB with Simulink (built in R2025b; use the same or a newer release). Project 09 also needs the Communications Toolbox. The package includes the builder script and the runner, so you can also rebuild the model and rerun the plots yourself.
Yes. Parameters are kept in the Model Workspace, so you can change values such as gains, capacities and profiles and rerun the simulation. If you would like us to adapt or extend the model for you, message us on WhatsApp.
The project costs US$24. Use the "Buy via WhatsApp" button on this page; the project files are delivered after payment is confirmed.
Found a problem or have a suggestion for this project? Tell us on WhatsApp
Back to MATLAB Simulink portfolio