Memuat
Memuat
Synthetic vibration is processed into a health index and alarms that trigger before the bearing fails completely.
0 views
A 30 Hz shaft vibration with harmonics and noise, plus bearing-defect impulses at 107.5 Hz whose amplitude grows quadratically and rings at 2 kHz. The signal passes a band-pass, absolute value and low-pass (envelope); RMS and kurtosis are computed with moving averages, merged into a health index, and two hysteresis Relays give warning and critical alarms.

A 30 Hz shaft rotation with 2x and 3x harmonics plus sensor noise.
Periodic impulses at the 107.5 Hz BPFO frequency with amplitude growing from 6 s, ringing at 2 kHz.
A two-stage 1.25 to 2.75 kHz band-pass, absolute value, then a 300 Hz low-pass.
A 1.5 s moving average built from a feedback integrator for x squared and x to the fourth.
HI = 0.6 times relative RMS + 0.4 times kurtosis/3; hysteresis Relays raise warning (1.6) and critical (3.0) alarms.
System
A synthetic accelerometer signal sampled at 20 kHz with an outer-race bearing defect (BPFO 107.5 Hz).
Scenario
A 36 s simulation on an accelerated timeline: a healthy bearing until 6 s, then the defect grows to the end.
Note: The vibration is synthetic, not a recording from a real machine, and the failure timeline is accelerated (36 s); the alarm thresholds must be recalibrated with real data.
Simulink model predictive_maintenance_bearing.slx (standard block diagram); Builder script buat_model.m and runner jalankan.m; Result plots grafik_bearing dan grafik_spektrum_envelope (PNG) and metrik.json; Step-by-step PDF guide (sent with the package; also part of the video class); Video tutorial in the MATLAB Simulink 2026 Trends class (this project's episode; episode 1 is free); Requires MATLAB and Simulink (built in R2025b); the slh.m builder helper is included.
Yes. The .slx model opens in MATLAB with Simulink (built in R2025b; use the same or a newer release). Project 09 also needs the Communications Toolbox. The package includes the builder script and the runner, so you can also rebuild the model and rerun the plots yourself.
Yes. Parameters are kept in the Model Workspace, so you can change values such as gains, capacities and profiles and rerun the simulation. If you would like us to adapt or extend the model for you, message us on WhatsApp.
The project costs US$17. Use the "Buy via WhatsApp" button on this page; the project files are delivered after payment is confirmed.
Found a problem or have a suggestion for this project? Tell us on WhatsApp
Back to MATLAB Simulink portfolio